- Location: Bullhead City, Arizona
- Accident Number: WPR23LA340
- Date & Time: September 5, 2023, 16:20 Local
- Registration: N58JB
- Aircraft: Rutan Long-EZ
- Aircraft Damage: Substantial
- Defining Event: Landing gear collapse
- Injuries: 1 None
- Flight Conducted Under: Part 91: General aviation - Personal
https://data.ntsb.gov/carol-repgen/api/Aviation/ReportMain/GenerateNewestReport/193050/pdf
https://data.ntsb.gov/Docket?ProjectID=193050
On September 5, 2023, about 1620 Pacific daylight time, a Rutan Long-EZ experimental airplane, N58JB, was substantially damaged when it was involved in an accident near Bullhead City, Arizona. The private pilot, the sole occupant, was not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.
The pilot stated that when he touched down, the main landing gear contacted the runway surface, followed by the nose gear. He instantly heard a loud “bang” as the nose gear collapsed and the nose continued to settle, sliding down the runway surface.
Examination of the nose gear revealed that the nose landing gear actuator failed due to the buckling and fracture of the ball screw, which resulted from compressive loads on the actuator assembly. These compressive loads were likely from vertical and/or aft loads on the nose wheel. The actuator was likely in the fully extended position, but the length of the accident actuator was longer than its design length at full extension. Issues with the actuator installation that might have contributed to the overextension could not be determined.
The examination further revealed that the nose landing gear likely sustained a relatively hard landing while in the fully extended position. However, the additional length in the overextended actuator assembly made the ball screw susceptible to buckling failure from lower compressive loads than designed. Additionally, since less length of the extension tube was constrained by the housing in the overextended assembly, the reduced constraint likely made the assembly susceptible to buckling at even lower loads. The assembly’s extension beyond its design length likely contributed to the failure, as the extension would have diminished the safety margin and increased the vulnerability to buckling failure under high landing loads.
- Probable Cause: The pilot’s improper flair resulting in a hard landing.
No comments:
Post a Comment